stopper machine - FDA.COMs Community Forums

Username

Post: stopper machine (Topic#3697)

hurricane
Beginner
Posts: 6

11-29-07 10:00 PM - Post#4278

help!i am a newer!who can tell me how to validate the inlet-air filter of the stopper machine? thanks a lot!

JohanJ
Member
Posts: 229
JohanJ

12-11-07 10:30 PM - Post#4297

In response to hurricane

Depends on the construction of the whole system.

But mostly the things you do on inlet filter is a performance test (DOP/EMERY) and you set up a schedule to replace it regularly.
If over the filter an deltaP measuring is set that will sound an alarm when the pressure drop gets to high, be sure that the dP value you put pre-set is conform the dP prescribed by the vendor of the filter.

Anyways the more imporatnt filters in such a systel are exhaust (final) filters which bring the air over your product (stoppers).

Is this a clear enough answer? if not skecth a bit your equipment setup.

regards

Johan Janssens
Mobile: +32 498 68 29 56
e-mail: johan.janssens@qualiphar.com

hurricane
Beginner
Posts: 6

12-21-07 01:50 PM - Post#4347

In response to JohanJ

THANK YOU VERY MUCH FOU YOUR HELP,JOHAN!